Product code: WEBER MASS III (150w) Attenuator / Powerbrake hot neuwertig
WEBER MASS III (150w) Attenuator / Powerbrake wie neu
·für mich einer der besten Attenuators
·der Mass III gibt den dynamischen und natürlichen Klang des Verstärkers original wieder
·4, 8, 10 Ohm
·Made in USA
·wie neu, ca. 3 Betriebsstunden
·technisch und optisch 100%
This attenuator has three knobs for tonal control. The main volume is controlled by the TREBLE knob. Then to control the mids and bass, use the MIDDLE knob and BASS knob. The middle and bass controls are always dependent on the main volume control. Be aware that the higher the setting on the main knob, the less the effect of the other knobs. For instance, if you turn the main knob all the way to 10, you'll notice very little change in the tone as you turn the other knobs compensation from one end to the other. The line out signal EQ is dependent on your amplifier settings, with only a volume and tone control on the unit.
May be used on 4, 8, and 16 ohm amplifiers. This MASS III is unique in that it has an actual tone stack for the speaker signal — BASS – MIDS – TREBLE. It also has the internal speaker motor for the load, and has a variable line out signal with volume and tone. The unit has two speaker output jacks to support multiple cabinets. The three tone controls can take the signal from whisper quiet to full on with slight humps in the bass, mids, and treble.
Like all Weber attenuators, you can turn all attenuator controls to zero, pull the speaker, and just use the line out, making the MASS III a dummy load.
Privatverkauf; keine Garantie; keine Gewährleistung; keine Rücknahme.
·für mich einer der besten Attenuators
·der Mass III gibt den dynamischen und natürlichen Klang des Verstärkers original wieder
·4, 8, 10 Ohm
·Made in USA
·wie neu, ca. 3 Betriebsstunden
·technisch und optisch 100%
This attenuator has three knobs for tonal control. The main volume is controlled by the TREBLE knob. Then to control the mids and bass, use the MIDDLE knob and BASS knob. The middle and bass controls are always dependent on the main volume control. Be aware that the higher the setting on the main knob, the less the effect of the other knobs. For instance, if you turn the main knob all the way to 10, you'll notice very little change in the tone as you turn the other knobs compensation from one end to the other. The line out signal EQ is dependent on your amplifier settings, with only a volume and tone control on the unit.
May be used on 4, 8, and 16 ohm amplifiers. This MASS III is unique in that it has an actual tone stack for the speaker signal — BASS – MIDS – TREBLE. It also has the internal speaker motor for the load, and has a variable line out signal with volume and tone. The unit has two speaker output jacks to support multiple cabinets. The three tone controls can take the signal from whisper quiet to full on with slight humps in the bass, mids, and treble.
Like all Weber attenuators, you can turn all attenuator controls to zero, pull the speaker, and just use the line out, making the MASS III a dummy load.
Privatverkauf; keine Garantie; keine Gewährleistung; keine Rücknahme.